COP Security 15-CD53 Manual do Utilizador descarregar pdf (Página 10)

Operation Function

Call + n + Enter To call the number N preset position

Preset + n + Enter To set the number N preset position

Preset + n + Off Delete the number N preset position

Cam + n + Enter Set the dome address “n”

Shot + n + Enter N=1：Auto the cruise track

Shot + n + Off N=1：Stop the cruise tracks

Wide ZOOM wide

Tele ZOOM tele

Far FOCUS far

Near FOCUS near

Open IRIS open

Close IRIS close

(1) Title Display Function

No.64 preset position can turn on or turn off the display function (including self-check information display) of some certain

cameras. If the No.64 preset position is a normal one, the camera does not have the display function (including

self-check information display).

(2) When camera performs cruise function, the tolerant state is as follows:

To scan point by point automatically from No. 1 preset position to No. 16 preset position. The cruise will not scan those

positions where certain positions are un-preset or deleted after preset, and resort time for each preset position is 3

seconds;

(3) When camera performs scan function, the tolerant state is as follows:

The camera will scan automatically between two designated positions, namely “starting point” (left) and “end point” (right).

The resort time at “starting point” and “end point” is 3 seconds; s

tates of dome camera are shown below. The dome

camera will stop scan and implement new action when receiving qualified command.

Note: The dome camera may result in accumulative deviation in parameters after serving a long period. The starting

point and end point of scan shall be reset.

(4) The item marked with * means the camera have this function, otherwise it will show “NO FUNCTION”。

5. Special Function—Power-off Protection

When the camera is under scan or cruise track, and power off occurs, the camera will save the state before the power-off.

When power is resupplied, the camera will continue to perform the scan or cruise track automatically under the same

state before power-off. Should scan or cruise track are not performed before power-off, the camera will stop at the first

preset position automatically.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Sem comentários

COP Security 15-CD53 Manual do Utilizador Página 10